Cold-installing HPUX 11i typically takes 2-3 hours, depending on the system and whether you are installing only the OS or also installing an OE.
To perform a cold installation follow the steps below:
1,Insert the HPUX 11i CD1 into the drive
2,stop the autoboot
3,ensure that Fast Boot is enabled(the full memory check run when Fast Boot is OFF may take several hours on a large system)
select the Confituration Menu: co
if the fast boot selection is available, switch fast boot on: fb on
return to the main menu:ma
(remember to switch fast boot back off after installing 11i)
4,search for bootable devices, using the choices displayed
5,boot from the CD drive using the listed path number
6,after a few minutes, you'll be asked "interact with IPL"? press:n
The install kernel will load, after which a screen might ask you to enter the keyboard language of your console. enter the number and press RETURN/ENTER and again to confirm
7,when the initial Ignite-UX screen appears, take a moment to read how to navigate and select choices using the terminal interface
8,select Install HPUX from the user interface and media options screen, choose:
source location options:media-only installation
user interface options:guided installation
9,whether using guided installation or advanced installation, proceed through each screen to configure your system
10,when finished configuring your installation:
with Guided Installation,select:finish
with advanced installation,select GO!
11,when prompted, replace HPUX 11i CD1 with the requested CD from the media kit
12,the system automatically reboots after all software has been loaded.
eject the last CD. be sure to store all CDs in a safe place. you may need them later to install drivers or to install or change the OE
13,if you specified "ask at first boot" during the instalation screens, the set_parms command runs now so you can set the root password, date, time, time zone, IP address, and other network parameters
14,the depot named GOLDQPK11i includes two quality pack bundles, GOLDAPPS11i, which updates OE applications, and GOLDBASE11i, which updates the base OE.
After installing or updating applications, insert the HP-UX Support Plus CD andinstall the Quality Pack patch bundles to update the Base OE and OE applications on your system. For example:
/usr/sbin/swinstall -s /cdrom/GOLDQPK11i \
-x patch_match_target=true -x autoreboot=true
阅读(1635) | 评论(0) | 转发(0) |