Right operation of not only can make the equipment work normally, but also reduce the failure rate, and extend the service life of concrete batching plant. In the following, Bona will introduce the correct starting sequence of concrete batching plant electric motor, and matters that the operators need pay much attention to before starting the concrete batching plant electric motor.Before you start the commercial concrete batching plant electric motor, and there are two necessary conditions: one is the air switch should be closed; the other is the contactor behind air switch should be pull-in. Then what is the correct order to finish the starting operation? At first, you should close the air switch, and then press the start button to make the contactor be pull-in.The improper operation of concrete batching plant electric motor will cause some influences: it will make electric circuit get stuck. Short circuit and overload phenomena are also likely to happen. When the protection of air switch breaks, press the hand grip. Avoid making air switch disconnect at this time, or it is inevitable for air switch to be burned down.In order to ensure power safety and personal security, all the tips mentioned above should be remembered by operators.
