u-boot-2010.06/drivers/mtd/nand/nand_spl_ids.c
第108行，添加这个NAND Flash
{ {0x2C, 0x88, 0x05, 0xC6, 0x89, 0x00, 0x00, 0x00}, 8, _16G, NULL, "MT29F128G08CJABA", _4K, _1M, 224, 0 },
2.编译uboot
make ARCH=arm CROSS_COMPILE=arm-hisiv100nptl-linux- godnet_config
make ARCH=arm CROSS_COMPILE=arm-hisiv100nptl-linux-
...
cp ../../../uboot/u-boot-2010.06/u-boot.bin ./
./mkboot.sh reg_info_930_310_620_ddr0_ddr1_slow.bin u-boot.bin
3.修改内核
linux-3.0.y/drivers/mtd/nand/nand_spl_ids.c
第68行,添加这个设备
{ {0x2C, 0x88, 0x05, 0xC6, 0x89, 0x00, 0x00, 0x00}, 8, _16G, NULL, "MT29F128G08CJABA", _4K, _1M, 224, 0 },
4.编译内核
cp arch/arm/configs/godnet_defconfig .config
make ARCH=arm CROSS_COMPILE=arm-hisiv100nptl-linux- menuconfig
make ARCH=arm CROSS_COMPILE=arm-hisiv100nptl-linux- uImage
cp arch/arm/boot/uImage ...
5.烧写u-boot
sf probe 0
mw.b 82000000 ff 100000
tftp 0x82000000 u-boot.bin
sf probe 0
sf erase 0 100000
sf write 82000000 0 100000
reset
6.烧写内核
mw.b 82000000 ff 400000
tftp 82000000 uImage
sf probe 0
sf erase 100000 400000
sf write 82000000 100000 400000
7.烧写文件系统
mw.b 82000000 ff b00000
tftp 0x82000000 rootfs_256k.jffs2
sf erase 500000 b00000
sf write 82000000 500000 b00000
8.设置启动参数
setenv bootargs 'mem=64M console=ttyAMA0,115200 root=/dev/mtdblock2 rootfstype=jffs2 mtdparts=hi_sfc:1M(boot),4M(kernel),11M(rootfs);hinand:16G(nand)'
setenv bootcmd 'sf probe 0;sf read 0x82000000 0x100000 0x400000;bootm 0x82000000'
sa
9.擦除NAND(可选)
nand erase
10.进入系统mount
mount /dev/mtdblock3 /mnt/ -t yaffs2
11.检查
# df
Filesystem 1K-blocks Used Available Use% Mounted on
/dev/root 11264 4632 6632 41% /
tmpfs 29196 4 29192 0% /dev
/dev/mtdblock3 16777216 13312 16763904 0% /mnt
一共16GByte，拷贝速度很快
12.其实不修改uboot也可以，这样uboot就认不到NAND Flash，也就没法在uboot erase，不过进系统了也可以用。
