分类: 信息化
2014-05-15 17:03:40
"" operation noise is too large: too much noise because the chain is not coplanar; chain tension is too big or too small; insufficient lubrication; "" and sprocket wear; or oversize chain pitch. The solution is: Check the front and rear axle parallel to the sprocket coplanarity condition to be corrected. Center distance adjustment and tensioning device, making proper tightness and ensure lubrication to the workpiece.
Side "" plate mill: If inner surface wear chain link plates serious and that is not aligned transmission. The solution is to check the alignment of the shaft and sprocket. If the installation is no problem, check whether substantial during operation because the load is too large deformation caused by lack of rigidity.
[This paper edited by "40MN motorcycle chain ", please indicate the source !]
Source: