分类： 信息化
2014-05-14 16:54:46
"" in the course of normal wear and tear will gradually stretch the chain, the chain sag results will gradually increase, the "415H motorcycle chain" produces severe beating, the chain increased wear and tear, or even jump teeth, tooth removal phenomenon, and therefore should adjust their tightness: loosen the rear axle nut, after holding a special tool to adjust the nut on the bracket in the clockwise direction, attention should be consistent on both sides, but the tightness of the "" at the time of observation between 10 ~ 20mm tighten the rear axle nut. When adjusting nut is rotated in the end and still comply with the tightness, indicating the chain wear elongation of more than 3% of the original length of the chain, the chain two sections should be removed or replaced with new chain and re-adjust the tightness of the "415H motorcycle chain" to the provisions of degree.
[This paper edited by "415H motorcycle chain ", please indicate the source !]
Source:
