USB设备类型代码（class类型）

This base class is defined for devices that are Wireless controllers. Values not shown in the table below are reserved. These class codes are to be used in Interface Descriptors, with the exception of the Bluetooth class code which can also be used in a Device Descriptor.

 

Base Class	SubClass	Protocol	Meaning
E0h	01h	01h	Bluetooth Programming Interface.  Get specific information from the Bluetooth SIG.
		02h	UWB Radio Control Interface.  Definition for this is found in the Wireless USB Specification in Chapter 8.
		03h	Remote NDIS.  Information can be found at:
	02h	01h	Host Wire Adapter Control/Data interface.  Definition can be found in the Wireless USB Specification in Chapter 8.
		02h	Device Wire Adapter Control/Data interface.  Definition can be found in the Wireless USB Specification in Chapter 8.
		03h	Device Wire Adapter Isochronous interface.  Definition can be found in the Wireless USB Specification in Chapter 8.

 

 

This base class is defined for miscellaneous device definitions. Values not shown in the table below are reserved.  The use of these class codes (Device or Interface descriptor) are specifically annotated in each entry below.

 

Base Class	SubClass	Protocol	Meaning
EFh	01h	01h	Active Sync device.  This class code can be used in either Device or Interface Descriptors.  Contact Microsoft for more information on this class.
		02h	Palm Sync.  This class code can be used in either Device or Interface Descriptors.
	02h	01h	Interface Association Descriptor.  The usage of this class code triple is defined in the Interface Association Descriptor ECN that is provided on .  This class code may only be used in Device Descriptors.
		02h	Wire Adapter Multifunction Peripheral programming interface. Definition can be found in the Wireless USB Specification in Chapter 8.  This class code may only be used in Device Descriptors
	03h	01h	Cable Based Association Framework.  This is defined in the Association Model addendum to the Wireless USB specification.  This class code may only be used in Interface Descriptors.

 

 

 

This base class is defined for devices that conform to several class specifications found on the USB-IF website.  That specification defines the usable set of SubClass and Protocol values.  Values outside of that defined spec are reserved.  These class codes can only be used in Interface Descriptors.

 

Base Class	SubClass	Protocol	Meaning
FEh	01h	01h	Device Firmware Upgrade.  Device class definition provided on .
	02h	00h	IRDA Bridge device.  Device class definition provided on .
	03h	00h	USB Test and Measurement Device.  Definition provided in the USB Test and Measurement Class spec found on .
		01h	USB Test and Measurement Device conforming to the USBTMC USB488 Subclass Specification found on

 

 

This base class is defined for vendors to use as they please.  These class codes can be used in both Device and Interface Descriptors.

 

Base Class	SubClass	Protocol	Meaning
FFh	xxh	xxh	Vendor specific