EMC PPP串口拨号连接

打开网上邻居
点创建一个新的连接
在出现的新建连接向导上点下一步
先择设置高级连接
点下一步
先择直接连接到其它计算机
点下一步
先来宾
点下一步
在名称中随便起一个连接的名字
点下一步
在选择设备中选择所用的COM口
点下一步
点完成
双击打开刚建立的连接
点属性
在常规选项卡上选择配置
设置最高速度为115200
在硬件功能中选中启用硬件流控制
点确定,再点确定
在用户名中输入:clariion  密码:clariion!
点连接
等连接完成(如在连接中报地址重名,可以拔出笔记本的网线,先断开网络连接)
打开IE浏览器
在地址栏中输入
在打开的页面中可以查看到IP地址了.
不同的机型连接方式基本相同,不同之处就在于使用的串口波特率
,所以,如果连接不成功,可以试试其它的速度.











a.      Follow the path:  Start ? Settings ? Control Panel ? Network and Dial Up Connections ? Make New Connection.

b.      When the Network Connection Wizard starts, click Next to begin.

c.      Click Connect directly to another computer and click Next.

d.      Select Guest and click Next.

e.      In the Select a Device pull-down menu, select Communications between two computers (COM 1) or select COM 2 if the cable is connected to COM 2.  Click Next.

f.       In the Connection Availability dialog box, select Create this connection: For all users and click Next.

g.      In the Completing Network Connection Wizard dialog box, assign the connection a name (for example, CX700init) and click Finish.

h.      In the Connect dialog box that appears (with the name you assigned to it), click Properties. 

i.        Under the General tab in the Properties dialog box, click Configure.

j.        In the Modem Configuration dialog box, select 115200 bps from the Maximum Speed pull-down list.  Verify that the Enable hardware flow control is checked.

 

k.      Click OK to close the dialog box.

l.        Click the Networking tab.

PPP: Windows 95/98/NT 4/2000, Internet should appear in the Type of dial-up server I am calling list.

 

m.     Click Settings.

 

n.      Verify that Enable LCP extensions and Enable software compression are checked, then click OK.

o.      Highlight Internet Protocol (TCP/IP) and click Properties.

 

p.      Select Obtain an IP address automatically and Obtain DNS server address automatically.

q.      Click Advanced.  Verify that Use IP header compression is checked.  Deselect Use default gateway on remote network. 

r.       Click OK three times to return to the Connect dialog box.

Click Cancel to close the Connect dialog box.  You will enter a username and password when you initialize the storage system at the customer site.

The service laptop is ready to initialize a storage processor at the customer site