分类： 系统运维
2013-06-05 11:17:57
多播 SUMMARY STEPS
1. 
enable
2. configure terminal
3. multicast-routing [distributed] //启用多播路由后面一条是SW上的
4. interface type number
5. Either perform Steps 6 and 7 and proceed to Step 9 or perform Step 8 and then proceed to Step 9.
6. ip pim sparse-mode ////SP
7. ip pim autorp listener /////让SP支持AUTO－RP
8. ip pim sparse-dense-mode ///sp&de模式
9. end
10. Repeat Steps 1 through 9 on all PIM interfaces.
11. ip pim send-rp-announce {interface-type interface-number | ip-address} scope ttl-value [group-list access-list] [interval seconds] [bidir] ///////C-RP
12. ip pim send-rp-discovery [interface-type interface-number] scope ttl-value [interval seconds] /////////MA
13. ip pim rp-announce-filter rp-list access-list group-list access-list ////RP过滤
14. no ip pim dm-fallback ////防止在SP&DE模式时RP挂了之后回到DE模式
15. interface type number
16. ip multicast boundary access-list [filter-autorp]
17. end
18. show ip pim autorp
19. show ip pim rp [mapping] [rp-address]
20. show ip igmp groups [group-name | group-address | interface-type interface-number] [detail]
21. show ip mroute [group-address | group-name] [source-address | source-name] [interface-type interface-number] [summary] [count] [active kbps]
