2012年（464）
分类：
2012-04-05 11:31:16
The development of large-sized machine still need further research on the
aspect of structural strength in order to improve the reliability during its
operation. The research and development of new material and technology,
especially the application of high performance material still need to further be
enhanced in order to reducing the weight of the machine and improve its quality
at the same time.
With the improvement of the requirement of environmental
protection, companies manufacturing Raymond mill should do further research on
the reduction of the machine noises and take some necessary measures,China
dryers keep the width and degree of the noise pollution into control. Its
development should go toward high technology and efficiency, low noise pollution
and energy consumption, fewer accidents and fewer ware and tear.
Installation
and operation maintenance of spiral :
(A)Installation:
The inspection machine damage, no loose screws can be installed. Grader should
be securely installed in the concrete pouring good. The basic design should have
a good supporting role to minimize the sheer force of the screw.
(B)Operation
of the structure and working principle of the spiral classifier to be
manipulating the machine.
1.Spiral rotation before they start giving into the
slurry, stingy to the amount of ore.
2.O'clock the the spirochete Department
the working status of, such as In case of specialfault such as stuck, O'clock
the overload that the) shall be immediately parking, immediately enhance the
will spirochete out of the on the magma surface, by no means permitted that the
spiral body pressure in the pulp within the, the-speed will the ore valve is
opened, to avoid blockage of.
3.Start again, shall spirochetes dropped to a
certain position in order to turn the spirochete.
4.The machine when in use,
such as parking, stop the feeding process to be materialgrading finished, no
material inside, to stop running
(C)Maintenance
1, where the lubrication
points are sodium based grease or calcium based grease lubrication.
2, each
class should view within the reducer lubricant needle engraved online every six
months for oil.
3, should always check the lower part of the bearing or the
bearing of the middle frame, bearings, seals wear, bearing damage, and for the
timely replacement.
4, the bearing lubrication every four hours of high
pressure oil to the bearing pressure injection using a dry pump manually, in
order to maintain the seal of the bearing performance.
With its high quality products such as , , , , , Henan Hongxing mining machinery Co.Ltd has ascended in the front rank of the world in the exporting of mining equipments.
