2012年（124）
分类： IT业界
2012-03-28 09:59:53
1. Preparation before Starting
(1) Check lubricating of main bearings;
check whether the toggle plate and movable jaw, underlay of upper toggle plate
can work well, and whether there is enough lubrication between toggle plate and
underlay of upper toggle plate.
(2) Check whether all fixed parts are well
fixed.
(3) Check whether the weight center of flying wheel and groove wheel
is all right. The weight center should be in line with eccentric shaft through
the central hole of main bearings.
(4) Check whether the belt is installed
well and replace with a new one if it is worn. Clear the belt wheel and groove
wheel
with clean cloth if there is any oil stain on them.
(5) Correct the
protecting devices if there are not in good condition.
(6) Check whether
there are any materials in the crushing groove and clear it.
(7) Check
whether the gasket is installed correctly or pressed tightly.
2. Starting of
Jaw Crusher
(1) Start the machine only after making sure that the machine and
transmission part can work in good condition.
(2) This machine can only start
in no -loading condition.
(3) Stop the machine immediately if any uncommon
phenomena occur. Start the machine only after checking and correcting.
3. Use
of Crusher
(1) Start feeding after checking that the machine works
well.
(2) Put the material evenly into the machine, and avoid putting
material from the side or feeding too much to avoid over feeding, sudden load
change or being blocked.
(3) Stop feeding before stops the machine. Stop the
motor after all the materials are discharged.
(4) Stop the motor if there is
any stagnancy due to the blocking up of material inside the machine.
(5) The
other side can be used if one side of fixed jaw plate and movable jaw plate are
worn.
(6) Check all fixed parts before starting to use and tighten the part
if it is loosening.
With its high quality products such as , , , , , Henan Hongxing mining machinery Co.Ltd has ascended in the front rank of the world in the exporting of mining equipments.
