Virus may lead to dislocation engraving machine

Control system is Weihong control, speed occurs only into the 1000 case of dislocation around the y-axis.

    I clean up a bit to check the y-axis on both sides of the rack above the debris, oil on again, the fault remains.

    Then put the new drive, or not.

    And then re-run the line the y direction, the fault remains.

    Editor's Note in the end it?

    No way, I saw his computer attached to broadband it will not be a virus destroyed the control system? cutting plotter

    Finally, re-do the computer system, failure to solve!

    A suggestion to our customers in this: the machine is best not to connect the computer to work broadband, some viruses may destroy engraving machine control software, so as not to cause unnecessary trouble to you!