SAN光交zone/LSAN配置

domainid可以通过 switchshow命令获取：
IBM-256-01:admin> switchshow |more
switchDomain:   25

cfg名称可以通过cfgshow命令获取：
IBM-256-01:admin> cfgshow |more
Defined configuration:
 cfg:   IBM_256_01_cfg

光交的每个端口号都有一个Index，Index和WWN可通过switchshow可以获取：
Index Slot Port Address Media Speed State     Proto
===================================================
  0    1    0   5e0000   id    N4   Online      FC  F-Port  50:06:0e:80:05:48:96:00

1、创建一般ZONE--[一台光交内]
SAN光交1
zonecreate "hostname_storage_sn","2;4;6;8"
cfgadd "IBM_256_01_cfg","hostname_storage_sn"
cfgenable "IBM_256_01_cfg"

2、创建一般ZONE--[级联光交]
[SAN光交1  domainid 25]<====>[SAN光交2  domainid 26]                  直连/级联模式

要把2台光交的Index为2,4,6,8,10打成一个ZONE：
zonecreate "hostname_storage_sn","25,2;25,4;25,6;25,8;26,2;26,4;26,6;26,8;"
cfgadd "IBM_256_01_cfg","hostname_storage_sn"
cfgenable "IBM_256_01_cfg"

在[SAN光交1]上创建了，会自动同步到[SAN光交2]去。

3、创建LSAN--[跨SAN路由]
[SAN光交1]<====>[SAN光交路由器]<====>[SAN光交3]
根据WWN来创建，名称必须以LSAN开头，且[SAN光交1]和[SAN光交3]都要配置：
zonecreate "LSAN_hostname1_hostname2_fc1","10:00:00:00:c9:ba:ae:30;21:00:00:24:ff:5c:63:4c"
zonecreate "LSAN_hostname1_hostname2_fc2","10:00:00:00:c9:ba:b7:52;21:00:00:24:ff:5c:62:0c"
cfgadd "IBM_256_01_cfg","LSAN_hostname1_hostname2_fc1"
cfgadd "IBM_256_01_cfg","LSAN_hostname1_hostname2_fc2"
cfgenable "IBM_256_01_cfg"

通过fcping来测试是否联通：
IBM-256-01:admin> fcping  10:00:00:00:c9:ba:b7:52   21:00:00:24:ff:5c:62:0c
Source:         10:00:00:00:c9:ba:b7:52  
Destination:    21:00:00:24:ff:5c:62:0c
Zone Check:     Zoned