Chinaunix首页 | 论坛 | 博客
  • 博客访问: 423496
  • 博文数量: 72
  • 博客积分: 1599
  • 博客等级: 上尉
  • 技术积分: 1125
  • 用 户 组: 普通用户
  • 注册时间: 2010-05-16 13:22
文章分类

全部博文(72)

文章存档

2014年(3)

2013年(8)

2012年(23)

2011年(23)

2010年(15)

分类: 服务器与存储

2013-07-14 23:52:04

System slow to POST with two or more QLogic HBAs installed - IBM BladeCenter and System x


可以解决IBM SYSTEM X系列如3550 M3机型插了HBA卡后并启用,出现无法从本地硬盘启动系统的问题。
  1. Start to the F1 Setup menu, Load Default Settings, then Save Settings and press Enter.
  2. Select System Settings --> Devices and I/O Ports--> Enable/Disable ADAPTER OPTION ROM SUPPORT --> Enable/Disable UEFI Option ROM(s) --> Disable the PCI slot where the Host Bus Adapter (HBA) is installed, under 'UEFI Options ROM(s).' Press the Escape key (ESC) twice and select Save Settings.
  3. Select System Settings --> Devices and I/O Ports --> Set Option ROM Execution Order. Press Enter.
  4. Move '' or '' for the Solid-State Drive (SSD) drive to the top of the list.
  5. Press ESC three (3) times and select Save Settings.
  6. Select System Settings --> Adapters And UEFI Drivers. Press Enter.
  7. Select QLogic Fibre Channel Driver. Press Enter.
  8. Press Enter to refresh the page.
  9. Select QLogic Fibre Channel Driver.
  10. From the Main menu screen, look under NVRAM parameters and select option (4), EDIT BOOT SETTINGS.
  11. Under EDIT BOOT SETTINGS, select the following items and enter 'y' (Yes):

    (2) Enable Alternate Start Device
    (3) Enable Selective Login
    (4) Enable Selective Logical Unit Number (LUN) Logins
    (6) Extensible Firmware Interface (EFI) Variable EFIFCScanLevel
    input a value of zero ('0')

  12. After this is done, type '0' at prompt to return to previous menu.
  13. At the MAIN MENU, type '11' for 'WRITE' to save the QLogic settings.
  14. Type '12' to exit.
  15. Repeat steps 6 though 14 for each 'QLogic Fibre Channel Driver' instance under the Adapters And UEFI Drivers menu.
  16. From the UEFI screen, save the settings and restart the server.

阅读(2523) | 评论(0) | 转发(0) |
给主人留下些什么吧!~~