NETAPP NAS的虚拟机是个不错的东东。拿来试玩一下。
1.在now.netapp.com上下载虚拟机软件，我这次下载的是7.2.4-sim-cdrom-image-v22.iso
2.安装ubunt
3.安装netapp nas simulator
mount /media/cdrom
cd /media/cdrom
bash setup.sh -z
4.初始化配置
./setup.sh
1. Enter a hostname that is unique for your environment. I suggest something like simulator
2. When asked Do you want to configure virtual network interfaces? [n]: press enter to select the default of no.
3. You will be asked Please enter the IP address for Network Interface ns0 [192.xxx.xxx.xxx]:
Please write the IP address given down somewhere as you will need it again shortly. Each simulator will be given a unique IP address and this is different per machine as VMware allocates different ranges at installation.
Press enter to select the given IP address.
4. Press enter when asked to Please enter the netmask for Network Interface ns0 [255.255.255.0]
5. Press enter to keep choosing the defaults for the following questions as they appear:
Please enter the IP address for Network Interface ns1: []
Would you like to continue setup through the web interface? [n]:
Please enter the IP address of the default gateway: [192.xxx.xxx.xxx]:
The administration host is given root access to the filer's
/etc files for system administration. To allow /etc root access
to all NFS clients enter RETURN below.
Please enter the name or IP address of the administration host:
6. When asked for the Timezone please enter the time zone for the area you are in.
7. Press enter to keep choosing the defaults for the following questions as they appear:
Where is the filer located? []:
What language will be used for multi-protocol files (Type ? for list)?:
Do you want to run DNS resolver? [n]:
Do you want to run NIS client? [n]:
8. You will now be asked to set the password. I recommend keeping it blank as long as the VMware network configuration is set to NAT. If you have set it to anything other than NAT then you should probably use a strong password.
Press enter to:
New password:
Retype new password:
9. The simulator should now complete the boot process and display several lines of configuration information.
10. You will then be asked to setup the CIFS protocol. At this point press Control + C as we do not want to set CIFS up at this point.
10. makedisks 新增硬盘
阅读(3473) | 评论(0) | 转发(1) |
