分类： BSD
2009-03-12 17:35:49
To help you prepare for total success on your Cisco certification exams, here are some complimentary practice exam questions. Answers are posted at the . Enjoy!
CCNA Certification And CCENT Certification:
BCMSN Answer: Just put the transport input ssh command on the VTY lines.
ONT Answer: Answer: Enabling Auto Discovery will begin the process of discovering the traffic types and flows on that interface; the auto qos command begins the process of generating and applying the MQC-based.
A Cisco switch can take one of three actions with an incoming frame. Name all three and describe under what conditions each action would occur.
CCNA Security Certification / CCNP ISCW Exam:
What is SDEE, and what do we use it for?
CCNP Certification / BSCI Exam:
OSPF Total Stub areas can contain which of the following OSPF ?
A. O
B. O IA
C. O* IA
D. O N1
E. O N2
CCNP Certification / BCMSN Exam:
What command will allow a Cisco switch to accept only secure remote connections? Where should this command ?
CCNP / ONT Exam:
What’s the difference between the two options shown below by IOS Help? What is the purpose of each?
R1(config)#int s0/0
R1(config-if)#auto ?
discovery Configure Auto Discovery
qos Configure AutoQoS
Here are the answers!
CCNA / CCENT Answer: If the switch’s MAC table has no entry for the destination MAC address of the frame, the frame will be flooded - that is, a copy of the frame is sent out every single port except the one it came in on.
If the switch’s MAC table does have an entry for the destination MAC address, and the source and destination are shown to be off different ports on the switch, the frame is unicast - sent out only the port leading to the destination address.
If the switch’s MAC table has an entry for the destination MAC, and the source and destination are shown to be off the same port, the frame is filtered by the switch - it’s not forwarded in any way.
CCNA Security / ISCW Exam Answer: SDEE (Security Device Event Exchange) is an application-layer protocol that allows the exchange of messages between an IPS server and client. SDEE pulls logs from our routers, and these logs can be viewed in SDM.
BSCI Answer: Here’s a quick review of the OSPF route types the different stub area types can contain:
Stub areas can contain O, O IA, and O* IA routes.
Total stub areas can contain O and O* IA routes only.
NSSAs can contain O, O IA, O N2, O* N2, O N1, and O* N1 routes.
Look for more practice exams and tutorials on my website as well as the one you’re on now!
Chris Bryant, CCIE #12933, is the owner of The Bryant Advantage, home of free CCNA Security and tutorials.
Get your CCNA with this special offer from The Bryant Advantage!
