U-Boot 2011.09 (Feb 22 2012 - 10:27:03)
DRAM: 64 MiB
NAND: 64 MiB
In: serial
Out: serial
Err: serial
Net: CS8900-0
Hit any key to stop autoboot: 0
Using CS8900-0 device
TFTP from server 192.168.1.50; our IP address is 192.168.1.222
Filename 'uImage'.
Load address: 0x30000000
Loading: #################################################################
#################################################################
########################
done
Bytes transferred = 2246408 (224708 hex)
## Booting kernel from Legacy Image at 30000000 ...
Image Name: Linux-2.6.39.4
Created: 2012-02-22 3:10:50 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2246344 Bytes = 2.1 MiB
Load Address: 30108000
Entry Point: 30108000
Verifying Checksum ... OK
Loading Kernel Image ... OK
OK
Starting kernel ...
Uncompressing Linux... done, booting the kernel.
Linux version 2.6.39.4 (root@localhost.localdomain) (gcc version 4.4.3 (ctng-1.6.1) ) #24 Wed Feb 22 11:10:43 CST 2012
CPU: ARM920T [41129200] revision 0 (ARMv4T), cr=00007177
CPU: VIVT data cache, VIVT instruction cache
Machine: SMDK2410
Memory policy: ECC disabled, Data cache writeback
CPU S3C2410A (id 0x32410002)
S3C24XX Clocks, Copyright 2004 Simtec Electronics
S3C2410: core 202.800 MHz, memory 101.400 MHz, peripheral 50.700 MHz
CLOCK: Slow mode (1.500 MHz), fast, MPLL on, UPLL on
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256
Kernel command line: noinitrd root=/dev/nfs console=ttySAC0 nfsroot=192.168.1.50:/pcy2410/fs/rootfs ip=192.168.1.222:192.168.1.50:192.168.1.1:255.255.255.0::eth0:off
PID hash table entries: 256 (order: -2, 1024 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 64MB = 64MB total
Memory: 60344k/60344k available, 5192k reserved, 0K highmem
Virtual kernel memory layout:
vector : 0xffff0000 - 0xffff1000 ( 4 kB)
fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB)
DMA : 0xffc00000 - 0xffe00000 ( 2 MB)
vmalloc : 0xc4800000 - 0xf6000000 ( 792 MB)
lowmem : 0xc0000000 - 0xc4000000 ( 64 MB)
modules : 0xbf000000 - 0xc0000000 ( 16 MB)
.init : 0xc0108000 - 0xc012e000 ( 152 kB)
.text : 0xc012e000 - 0xc051c5b8 (4026 kB)
.data : 0xc051e000 - 0xc054bba0 ( 183 kB)
NR_IRQS:99
irq: clearing pending ext status 00000200
irq: clearing subpending status 00000002
Console: colour dummy device 80x30
console [ttySAC0] enabled
Calibrating delay loop... 50.17 BogoMIPS (lpj=125440)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
S3C Power Management, Copyright 2004 Simtec Electronics
S3C2410: Initialising architecture
bio: create slab at 0
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
s3c-i2c s3c2410-i2c: slave address 0x10
s3c-i2c s3c2410-i2c: bus frequency set to 99 KHz
s3c-i2c s3c2410-i2c: i2c-0: S3C I2C adapter
Advanced Linux Sound Architecture Driver Version 1.0.24.
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
RPC: Registered tcp NFSv4.1 backchannel transport module.
NetWinder Floating Point Emulator V0.97 (extended precision)
JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc.
ROMFS MTD (C) 2007 Red Hat, Inc.
msgmni has been set to 117
io scheduler noop registered
io scheduler deadline registered
io scheduler cfq registered (default)
s3c2410-lcd s3c2410-lcd: no platform data for lcd, cannot attach
s3c2410-lcd: probe of s3c2410-lcd failed with error -22
Serial: 8250/16550 driver, 4 ports, IRQ sharing enabled
s3c2410-uart.0: ttySAC0 at MMIO 0x50000000 (irq = 70) is a S3C2410
s3c2410-uart.1: ttySAC1 at MMIO 0x50004000 (irq = 73) is a S3C2410
s3c2410-uart.2: ttySAC2 at MMIO 0x50008000 (irq = 76) is a S3C2410
lp: driver loaded but no devices found
ppdev: user-space parallel port driver
brd: module loaded
loop: module loaded
Uniform Multi-Platform E-IDE driver
ide-gd driver 1.18
ide-cd driver 5.00
S3C24XX NAND Driver, (c) 2004 Simtec Electronics
s3c24xx-nand s3c2410-nand: Tacls=3, 29ns Twrph0=7 69ns, Twrph1=3 29ns
s3c24xx-nand s3c2410-nand: NAND soft ECC
NAND device: Manufacturer ID: 0xec, Chip ID: 0x76 (Samsung NAND 64MiB 3,3V 8-bit)
Scanning device for bad blocks
Creating 4 MTD partitions on "NAND":
0x000000000000-0x0000000f0000 : "U-BOOT"
0x0000000f0000-0x000000100000 : "U-BOOT-ENV"
0x000000100000-0x000000500000 : "KERNEL"
0x000000500000-0x000004000000 : "YAFFS2"
eth0: cs8900 rev K found at 0xfa000300
cs89x0: Extended EEPROM checksum bad and no Cirrus EEPROM, relying on command line
cs89x0 media RJ-45, IRQ 53, programmed I/O, MAC 00:00:c0:5a:a5:ff
cs89x0: request_region(0xfa000300, 0x10) failed
cs89x0: no cs8900 or cs8920 detected. Be sure to disable PnP with SETUP
usbmon: debugfs is not available
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
s3c2410-ohci s3c2410-ohci: S3C24XX OHCI
s3c2410-ohci s3c2410-ohci: new USB bus registered, assigned bus number 1
s3c2410-ohci s3c2410-ohci: irq 42, io mem 0x49000000
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
usbcore: registered new interface driver libusual
usbcore: registered new interface driver usbserial
USB Serial support registered for generic
usbcore: registered new interface driver usbserial_generic
usbserial: USB Serial Driver core
USB Serial support registered for FTDI USB Serial Device
usbcore: registered new interface driver ftdi_sio
ftdi_sio: v1.6.0:USB FTDI Serial Converters Driver
USB Serial support registered for pl2303
usbcore: registered new interface driver pl2303
pl2303: Prolific PL2303 USB to serial adaptor driver
mousedev: PS/2 mouse device common for all mice
S3C24XX RTC, (c) 2004,2006 Simtec Electronics
S3C2410 Watchdog Timer, (c) 2004 Simtec Electronics
s3c2410-wdt s3c2410-wdt: watchdog inactive, reset disabled, irq enabled
ALSA device list:
No soundcards found.
TCP cubic registered
NET: Registered protocol family 17
drivers/rtc/hctosys.c: unable to open rtc device (rtc0)
eth0: using half-duplex 10Base-T (RJ-45)
IP-Config: Complete:
device=eth0, addr=192.168.1.222, mask=255.255.255.0, gw=192.168.1.1,
host=192.168.1.222, domain=, nis-domain=(none),
bootserver=192.168.1.50, rootserver=192.168.1.50, rootpath=
VFS: Mounted root (nfs filesystem) on device 0:12.
Freeing init memory: 152K
=========================================================================
_ _____ __ __ _ _
/ \ / __ \ / \_/ \ | | |_|
/ _ \ | | | | / /\ /\ \ ____ | | _ ___ _ _ _ _
/ /_\ \ | |__| | / / \_/ \ \ |____| | | | |/ _ \| | | |\ \/ /
/ /___\ \ | |__\ \ | | | | | |___ | | | | | |_| |/ \
/_/ \_\| | \_\|_| |_| |_____||_|_| |_|\____|\_/\_/
=========================================================================
/ #
阅读(3696) | 评论(0) | 转发(1) |