PC系统:Fedora 11(完全安装)
如果你完全安装了Fedora 11,系统中已经存在minicom软件包,无需单独下载或安装。在进行配置时要切换为root权限。下面为详细步骤。
1.在命令行中输入如下命令切换为root权限
[work@localhost ~]$ su
密码:******
[root@localhost work]#
2.配置minicom
[root@localhost work]# minicom -s
+-----[configuration]------+
| Filenames and paths |
| File transfer protocols |
| Serial port setup |
| Modem and dialing |
| Screen and keyboard |
| Save setup as dfl |
| Save setup as.. |
| Exit |
| Exit from Minicom |
+------------------------------+
1>Serial port setup选项
+-----------------------------------------------------------------------+
| A - Serial Device : /dev/ttyUSB0 |
| B - Lockfile Location : /var/unlock |
| C - Callin Program : |
| D - Callout Program : |
| E - Bps/Par/Bits : 115200 8N1 |
| F - Hardware Flow Control : No |
| G - Software Flow Control : No |
| |
| Change which setting? |
+-----------------------------------------------------------------------+
因为我的电脑是笔记本,没有串行口,使用OPENJTAG,因此A项配置为/dev/ttyUSB0;若为有串行口计算机可直接配置为/dev/ttySAC0。其他选项按照图像要求即可。然后按回车退出该项设置。
2>Modem and dialing选项
进入这个选项后, 将A、B、K子选项的内容全部清除,如下:
+--------------------[Modem and dialing parameter setup]---------------------+
| |
| A - Init string ......... |
| B - Reset string ........ |
| C - Dialing prefix #1.... ATDT |
| D - Dialing suffix #1.... ^M |
| E - Dialing prefix #2.... ATDP |
| F - Dialing suffix #2.... ^M |
| G - Dialing prefix #3.... ATX1DT |
| H - Dialing suffix #3.... ;X4D^M |
| I - Connect string ...... CONNECT |
| J - No connect strings .. NO CARRIER BUSY |
| NO DIALTONE VOICE |
| K - Hang-up string ...... |
| L - Dial cancel string .. ^M |
| |
| M - Dial time ........... 45 Q - Auto bps detect ..... No |
| N - Delay before redial . 2 R - Modem has DCD line .. Yes |
| O - Number of tries ..... 10 S - Status line shows ... DTE speed |
| P - DTR drop time (0=no). 1 T - Multi-line untag .... No |
| |
| Change which setting? (Return or Esc to exit) |
+----------------------------------------------------------------------------+
按回车退出,又回到主菜单。
3.保存配置
将光标移动到Save setup as dfl,确定保存配置。
4.退出配置
将光标移动到Exit from Minicom或Exit选项,确定退出。其中,前者退出的是minicom,后者只是退出配置状态而进入minicom。
到此,minicom的配置就完成了。要注意的是,运行minicom必须要在root权限下运行,否则会提示没有权限。
阅读(947) | 评论(0) | 转发(0) |