Managing and Configuring Cisco VoIP Devices(2)

Topology

 

 

Task 1:Configure the Cisco IP Phone Using the telephony-service setup command

Step 1: Ensure that the routes has no previously configured command

Step 2: From global configration mode , enter the telephony-service setup command to enter CME telephony setup mode

RouterVoIPX(config)#telephony-service setup

Step 3: when prompted with the choice to set up the DHCP service for you IP Phone, enter Y and press Enter.

Step 4: The Ip netork for the telp-service DHCP pool is 10.x5.0.0 This is a DHCP pool to be used by the IP phones

Step5: The subnet mask for the DHCP network is :255.255.255.0

Step 6: The TFTP server IP address for DHCP option 150 is an addresses on the Cisco CME router 10.x5.0.1.

Step 7: The default router for the pool also is 10.x5.0.1

Step 8: when you are asked if you want to start the telp-service setup, answer y for yes.

Step 9:For the source IP address, enter 10.x5.0.1

Step 10: Accept the default port of 2000 by pressing the Enter Key, Skinny is a protocol used by Cisco IP Phones ,It uses TCP port 2000

Step 11:When asked how many phones to configure, respond with 4, even though only two phones are connected.

Step 12:when asked whether you want dula lines, answer y and press enter.

Step 13: Select the language you want to on the phone(you can accept the default of english by simply pressing the enter key)

Step 14:Wehn asked which Call Progress tone to use, select a number relating to the country for call progress tones.

Step 15:Refer the tables to find the approoriate first extension number, The second extension number, find the appropriate row for the pod number being used, Select the first number in the range for the pod being used, For example ,if Pod 1 is being used, the first extension number is 5000.

Step 16: when you are asked if Direct Inward Dialing is used, answer y and press enter

Step 17: when you are asked for the full E.164 number, enter the value from table for the pod being used, for example ,if pod 2 is being used, the E.164 DID number is 5001555030

Step 18: When you are asked if you want forwarding to a voice message service(voice mail) enter y and press enter.

Step 19: when you are asked to enter an extension or pilot number of the voice message servie ,refer to table for the voice mail extension number, for example ,if pod 3 is being used, the voice mail extension number is 5555088

Step 20: press the Enter key to accept the default of 18 seconds for Call Forward timeout

Step 21: You are asked if nay of the information needs to be changed, select no to use the current settings and to exit , or select yes to change an option, if you did not make mistakes in the previous steps, enter n ,press Enter, and proceed to the next step ,if you made  mistakes, enter y press enter and go back to the first step

step 22: watch the console output to see if the phones register, you should see router output similar to the following.

 

Task 3: connect a PC to the Cisco IP Phone port and verify the configuration

if you want to use the DHCP to get the IP address

ip dhcp pool DATA

network 10.x0.0.0 255.255.255.0

default-router 10.x0.0.1

ip dhcp excluded-address 10.x0.0.1 10.x0.0.10