从里面摘取出来的一段:
Reset Generation
As a general rule, reset (RST) must be sent whenever a segment arrives
which apparently is not intended for the current connection. A reset
must not be sent if it is not clear that this is the case.
There are three groups of states:
1. If the connection does not exist (CLOSED) then a reset is sent
in response to any incoming segment except another reset. In
particular, SYNs addressed to a non-existent connection are rejected
by this means.
If the incoming segment has an ACK field, the reset takes its
sequence number from the ACK field of the segment, otherwise the
reset has sequence number zero and the ACK field is set to the sum
of the sequence number and segment length of the incoming segment.
The connection remains in the CLOSED state.
2. If the connection is in any non-synchronized state (LISTEN,
SYN-SENT, SYN-RECEIVED), and the incoming segment acknowledges
something not yet sent (the segment carries an unacceptable ACK), or
if an incoming segment has a security level or compartment which
does not exactly match the level and compartment requested for the
connection, a reset is sent.
If our SYN has not been acknowledged and the precedence level of the
incoming segment is higher than the precedence level requested then
either raise the local precedence level (if allowed by the user and
the system) or send a reset; or if the precedence level of the
incoming segment is lower than the precedence level requested then
continue as if the precedence matched exactly (if the remote
cannot raise the precedence level to match ours this will be
detected in the next segment it sends, and the connection will be
terminated then). If our SYN has been acknowledged (perhaps in this
incoming segment) the precedence level of the incoming segment must
match the local precedence level exactly, if it does not a reset
must be sent.
If the incoming segment has an ACK field, the reset takes its
sequence number from the ACK field of the segment, otherwise the
reset has sequence number zero and the ACK field is set to the sum
of the sequence number and segment length of the incoming segment.
The connection remains in the same state.
3. If the connection is in a synchronized state (ESTABLISHED,
FIN-WAIT-1, FIN-WAIT-2, CLOSE-WAIT, CLOSING, LAST-ACK, TIME-WAIT),
any unacceptable segment (out of window sequence number or
unacceptible acknowledgment number) must elicit only an empty
acknowledgment segment containing the current send-sequence number
and an acknowledgment indicating the next sequence number expected
to be received, and the connection remains in the same state.
If an incoming segment has a security level, or compartment, or
precedence which does not exactly match the level, and compartment,
and precedence requested for the connection,a reset is sent and
connection goes to the CLOSED state. The reset takes its sequence
number from the ACK field of the incoming segment.
Reset Processing
In all states except SYN-SENT, all reset (RST) segments are validated
by checking their SEQ-fields. A reset is valid if its sequence number
is in the window. In the SYN-SENT state (a RST received in response
to an initial SYN), the RST is acceptable if the ACK field
acknowledges the SYN.
The receiver of a RST first validates it, then changes state. If the
receiver was in the LISTEN state, it ignores it. If the receiver was
in SYN-RECEIVED state and had previously been in the LISTEN state,
then the receiver returns to the LISTEN state, otherwise the receiver
aborts the connection and goes to the CLOSED state. If the receiver
was in any other state, it aborts the connection and advises the user
and goes to the CLOSED state.
阅读(1641) | 评论(0) | 转发(0) |