一台solaris 10 u6版本，安装配置好vxvm 5.0后，想利用它来克隆到其他服务器上，
配置完jumpstart后，机器可以顺利安装。启动后发现kenerl 占用率非常的高，百思不解。
最后查到一段资料，如果一定要这么做，最好是在vxvm 配置前做flash，然后再克隆，非常安全，因为vxvm有些配置是flash无法导出的，所以克隆的机器，实际上是不能用的。
top显示
last pid: 2418; load avg: 2.61, 2.62, 2.32; up 0+00:35:39 15:41:45
62 processes: 61 sleeping, 1 on cpu
CPU states: 22.2% idle, 7.6% user, 70.3% kernel, 0.0% iowait, 0.0% swap
Memory: 4096M phys mem, 2480M free mem, 2000M total swap, 1009M free swap
PID USERNAME LWP PRI NICE SIZE RES STATE TIME CPU COMMAND
1694 root 1 60 0 1656K 1084K sleep 0:05 10.29% cpio
1596 root 1 50 0 6308K 5540K sleep 1:52 2.66% ppdmgr
3508 noaccess 18 59 0 163M 88M sleep 1:22 1.01% java
10519 root 2 58 0 42M 33M sleep 0:26 0.81% perl
1 root 1 59 0 2476K 1188K sleep 0:26 0.50% init
2414 root 1 50 0 1516K 1000K sleep 0:00 0.42% gzgrep
2417 root 1 60 0 1692K 728K sleep 0:00 0.32% gzip
2418 root 1 50 0 1400K 836K sleep 0:00 0.29% egrep
2231 root 1 49 0 3004K 1660K cpu/0 0:00 0.26% top
9 root 12 59 0 9428K 7892K sleep 1:25 0.22% svc.configd
389 root 31 59 0 5312K 2064K sleep 0:01 0.17% nscd
495 root 1 100 -20 2536K 1244K sleep 0:02 0.03% xntpd
1907 root 3 59 0 2796K 1744K sleep 0:00 0.02% automountd
4829 root 1 59 0 5556K 1580K sleep 0:00 0.02% dtlogin
2092 root 1 59 0 5972K 2068K sleep 0:00 0.02% sshd
Note - Veritas VxVM stores configuration information in areas not available to Solaris Flash.
If Veritas VxVm file systems have been configured, you should not create a Solaris Flash archive.
Also, Solaris install, including JumpStart and Solaris Live Upgrade do not support rebuilding VxVM
volumes at installation time. Therefore, if you are planning to deploy Veritas VxVM software using a
Solaris Flash archive, the archive must be created prior to configuring the VxVM file systems.
The clone systems must be then configured individually after the archive has been applied and the
system rebooted.
阅读(1372) | 评论(0) | 转发(0) |
