Chinaunix首页 | 论坛 | 博客
  • 博客访问: 99659
  • 博文数量: 12
  • 博客积分: 1520
  • 博客等级: 上尉
  • 技术积分: 235
  • 用 户 组: 普通用户
  • 注册时间: 2005-12-28 11:22
文章分类

全部博文(12)

文章存档

2008年(12)

我的朋友
最近访客

分类: 系统运维

2008-06-23 15:42:25

1.启用超级终端并出现连接界面。

2.拔掉交换机的电源。

3.按下交换机上的Mode按钮,与此同时,重新插上交换机的电源线。

4.当交换机左边的sys灯会慢慢的闪动,(细心的话会发现部分灯红色的闪过),按住mode按钮直到sys灯不闪动(常亮状态).否则提前松开的按钮的话会直接进入正常的启动,必须跳回步骤2重新来做。     

5.可以松开Mode按钮。

之后系统将显示一些指示信息:
The system has been interrupted prior to initializing the flash file system. The following
commands will initialize the flash file system, and finish loading the operating system
software:

flash_init   /---初始化flash文件系统---/
load_helper  /---
加载帮助文件---/
boot         /---
启动设备进入正常的模式---/


步骤:
switch:
Switch:flash_init
  
Switch:dir flash:     /---
查看Flash的文件名字可以用来确认文件名为config.text---/            

Switch:rename flash:config.text flash:config.text.old /---把配置文件重命名,当然你可以不改为config.text.old,只要文件名和原来的不相同就可以---/
Switch:boot          /---
手动启动交换机---/

由于配置文件改过了,所以交换机找不到默认的config.text而出现配置的对话向导,选择n然后回车然后我们就会绕过原来的password而进入到:
Switch>
Switch>en
  /--
可以进入特权模式--/
Switch#rename flash:config.text.old flash:config.text    /---
恢复交换机配置文件---/
Switch#copy flash:config.text system:running-config     /---
保存配置到DRAM---/
Switch#config t
Switch(config)#no enable password
             /---
干掉特权模式旧密码---/
Switch(config)#no enable secret              
/---干掉加秘密码---/

Switch(config)#exit
Switch#copy run start        /---
把当前配置的文件写回Flash---/


用这个方法修改密码不会把原来的配置文件内容清掉。特别是一个现成的大型网络里已经在运行的交换机,这样比较保险点。

阅读(693) | 评论(0) | 转发(0) |
给主人留下些什么吧!~~