asmlinkage void __init start_kernel(void)
{
char * command_line;
extern struct kernel_param __start___param[], __stop___param[];
/*
* Interrupts are still disabled. Do necessary setups, then
* enable them
*/
lock_kernel();
page_address_init();
printk(KERN_NOTICE);
printk(linux_banner);
setup_arch(&command_line);
setup_per_cpu_areas();
/*
* Mark the boot cpu "online" so that it can call console drivers in
* printk() and can access its per-cpu storage.
*/
smp_prepare_boot_cpu();
/*
* Set up the scheduler prior starting any interrupts (such as the
* timer interrupt). Full topology setup happens at smp_init()
* time - but meanwhile we still have a functioning scheduler.
*/
sched_init();
/*
* Disable preemption - early bootup scheduling is extremely
* fragile until we cpu_idle() for the first time.
*/
preempt_disable();
build_all_zonelists();
page_alloc_init();
printk(KERN_NOTICE "Kernel command line: %s\n", saved_command_line);
parse_early_param();
parse_args("Booting kernel", command_line, __start___param,
__stop___param - __start___param,
&unknown_bootoption);
sort_main_extable();
trap_init();
rcu_init();
init_IRQ();
pidhash_init();
init_timers();
softirq_init();
time_init();
/*
* HACK ALERT! This is early. We're enabling the console before
* we've done PCI setups etc, and console_init() must be aware of
* this. But we do want output early, in case something goes wrong.
*/
console_init();
if (panic_later)
panic(panic_later, panic_param);
profile_init();
local_irq_enable();
#ifdef CONFIG_BLK_DEV_INITRD
if (initrd_start && !initrd_below_start_ok &&
initrd_start < min_low_pfn << PAGE_SHIFT) {
printk(KERN_CRIT "initrd overwritten (0x%08lx < 0x%08lx) - "
"disabling it.\n",initrd_start,min_low_pfn << PAGE_SHIFT);
initrd_start = 0;
}
#endif
vfs_caches_init_early();
mem_init();
kmem_cache_init();
setup_per_cpu_pageset();
numa_policy_init();
if (late_time_init)
late_time_init();
calibrate_delay();
pidmap_init();
pgtable_cache_init();
prio_tree_init();
anon_vma_init();
#ifdef CONFIG_X86
if (efi_enabled)
efi_enter_virtual_mode();
#endif
fork_init(num_physpages);
proc_caches_init();
buffer_init();
unnamed_dev_init();
key_init();
security_init();
vfs_caches_init(num_physpages);
radix_tree_init();
signals_init();
/* rootfs populating might need page-writeback */
page_writeback_init();
#ifdef CONFIG_PROC_FS
proc_root_init();
#endif
cpuset_init();
check_bugs();
acpi_early_init(); /* before LAPIC and SMP init */
/* Do the rest non-__init'ed, we're now alive */
rest_init();
}
、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、
static void noinline rest_init(void)
__releases(kernel_lock)
{
/*********************************************************
int kernel_thread(int (*fn)(void *), void * arg, unsigned long flags);
****************************************************************/
kernel_thread(init, NULL, CLONE_FS | CLONE_SIGHAND);//通过函数指针调用init函数
numa_default_policy();
unlock_kernel();
preempt_enable_no_resched();
/*
* The boot idle thread must execute schedule()
* at least one to get things moving:
*/
schedule();
cpu_idle();
}
、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、、
static int init(void * unused)
{
lock_kernel();
/*
* init can run on any cpu.
*/
set_cpus_allowed(current, CPU_MASK_ALL);
/*
* Tell the world that we're going to be the grim
* reaper of innocent orphaned children.
*
* We don't want people to have to make incorrect
* assumptions about where in the task array this
* can be found.
*/
child_reaper = current;
/* Sets up cpus_possible() */
smp_prepare_cpus(max_cpus);
do_pre_smp_initcalls();
fixup_cpu_present_map();
smp_init();
sched_init_smp();
cpuset_init_smp();
/*
* Do this before initcalls, because some drivers want to access
* firmware files.
*/
populate_rootfs();
do_basic_setup();
/*
* check if there is an early userspace init. If yes, let it do all
* the work
*/
if (!ramdisk_execute_command)
ramdisk_execute_command = "/init";
if (sys_access((const char __user *) ramdisk_execute_command, 0) != 0) {
ramdisk_execute_command = NULL;
prepare_namespace();
}
/*
* Ok, we have completed the initial bootup, and
* we're essentially up and running. Get rid of the
* initmem segments and start the user-mode stuff..
*/
free_initmem();
unlock_kernel();
system_state = SYSTEM_RUNNING;
numa_default_policy();
if (sys_open((const char __user *) "/dev/console", O_RDWR, 0) < 0)
printk(KERN_WARNING "Warning: unable to open an initial console.\n");
(void) sys_dup(0);
(void) sys_dup(0);
if (ramdisk_execute_command) {
run_init_process(ramdisk_execute_command);
printk(KERN_WARNING "Failed to execute %s\n",
ramdisk_execute_command);
}
/*
* We try each of these until one succeeds.
*
* The Bourne shell can be used instead of init if we are
* trying to recover a really broken machine.
*/
if (execute_command) {
run_init_process(execute_command);
printk(KERN_WARNING "Failed to execute %s. Attempting "
"defaults...\n", execute_command);
}
run_init_process("/sbin/init");
run_init_process("/etc/init");
run_init_process("/bin/init");
run_init_process("/bin/sh");
panic("No init found. Try passing init= option to kernel.");
}
static void __init do_basic_setup(void)
{
/* drivers will send hotplug events */
init_workqueues();
usermodehelper_init();
driver_init();
#ifdef CONFIG_SYSCTL
sysctl_init();
#endif
/* Networking initialization needs a process context */
sock_init();
do_initcalls();
//init内核进程调用了do_basic_setup 函数，这个函数依次调用do_initcalls函数遍历由_initcall或者module_init宏注册的函数列表，并调用他们
}
static void __init do_initcalls(void)
{
initcall_t *call;
int count = preempt_count();
for (call = __initcall_start; call < __initcall_end; call++) {
char *msg;
if (initcall_debug) {
printk(KERN_DEBUG "Calling initcall 0x%p", *call);
print_fn_descriptor_symbol(": %s()", (unsigned long) *call);
printk("\n");
}
(*call)();//顺序调用__init段中的init_module注册的初始化函数
msg = NULL;
if (preempt_count() != count) {
msg = "preemption imbalance";
preempt_count() = count;
}
if (irqs_disabled()) {
msg = "disabled interrupts";
local_irq_enable();
}
if (msg) {
printk(KERN_WARNING "error in initcall at 0x%p: "
"returned with %s\n", *call, msg);
}
}
/* Make sure there is no pending stuff from the initcall sequence */
flush_scheduled_work();
}
