头疼的SUSE Server 10

    昨天晚上终于把SESU盘刻好了，以高昂的热情装上了，迫不及待的打开界面，一看分辨率，刷新率太不合显示器了，调了一下，然后就没有显示效果了，（好像是在安装的最后一部，配置硬件的时候就没有画面了，我就按下了重启按钮）。我好像太心急了。但是弄了半天还是不行，于是乎，我就又装了一遍，又是这个问题，终于明白了，应该是显卡的问题！恩，晓得了，先看看nvidia的网站看看关于SESU的显卡驱动是怎么回事再说吧，我就不信我会治不了它！！！！

    nvidia网站上说SESU的显卡驱动和别的linux安装有些不同，在现在页面上看到一句这样的话：

SuSE users: please read the before downloading the driver.

    打开连接，有这样一段话：

It is recommended to use YOU (YaST Online Update) for (re)installation
of the nvidia driver. There are several reasons for this. First, it's
simple. Second, and this is the most important one, you won't need to
recompile the nvidia kernel module after a kernel update.

Inside YOU enable "Installable and Installed Patches" for "Show Patch
Category" and select "Download NVIDIA(r) Graphics Driver" from the
patches list (usually at the bottom of the list). Note, that you need
to mark it as "Update" (right mouse click) if you already installed it
before and the driver was uninstalled - for any reason. Proceed as
usual now. After YOU has finished restart your Xserver (i.e. logout
from your Xsession) and you're fine.

People who aren't afraid of recompiling the nvidia kernel module or
even reinstalling the nvidia driver each time the kernel has been
updated and want or need to use the latest and greatest nvidia driver
can use the following steps 1-3. The others should use the
instructions above using YOU and skip the steps below.

1) Kernel sources must be installed and configured. Usually this means
installing the 'kernel-source', 'make' and 'gcc' packages with YaST2. 
Update it - if not already done - via YaST2 Online Update (YOU).

2) Use the nvidia installer for 1.0-9746.

 sh NVIDIA-Linux-x86-1.0-9746-pkg1.run -q

3) Configure X.Org with

 sax2 -m 0=nvidia (0 is a digit, not a letter!)

NOTE: There is no need to try to enable 3D support. It's already
      enabled, when the nvidia driver is running.

    但是那个什么“YOU”我还不知道是什么东西，不过我会搞清楚的！

    等晚上回来再说吧，小样，看我怎么治你！嘿嘿！