Chinaunix首页 | 论坛 | 博客
  • 博客访问: 289318
  • 博文数量: 469
  • 博客积分: 2510
  • 博客等级: 少校
  • 技术积分: 5200
  • 用 户 组: 普通用户
  • 注册时间: 2008-06-03 16:15
文章分类

全部博文(469)

文章存档

2011年(82)

2010年(284)

2009年(69)

2008年(34)

我的朋友

分类:

2011-01-05 10:03:36

考试题库由我们专业IT认证讲师及产品专家精心打造,包括了当前最新的全真考试试题,全部附有正确答案。题库的覆盖率在96%以上,在考试认证厂商对考题做出变化时,网站都将在第一时间内更新,最终确保考生能一次通过考试。

以下是题库的部分题目,和大家分享了:

1.When installing drum drive motors from service parts________.

A. the motors are optimized for any color and can be used with any color

B. each color (C, M, Y, K) has its own drum drive motor part number, optimized for that color

C. all motors must be replaced as a set

D. the fusible link burns up and resets the drum driver counters

Answer: A

2.The HP Color LaserJet 4700 automatically calibrates and cleans at certain times to maintain optimum print quality. Which of the following conditions cause the device to perform a color-plane registration (CPR)? Select THREE.

A. one or more print cartridges are installed that have not previously been installed in the printing device

B. 10,000 pages have printed since the last calibration

C. 'Full Calibrate Now' is requested through the control panel

D. the ETB is replaced

Answer: A,C,D

3.Before performing an engine test on the HP Color LaserJet 4700ph+,________.

A. the printing device must be powered off

B. the printing device must be power-cycled

C. the output device connection cable must be detached from the printing device

D. the output device and output accessory bridge must be removed

Answer: B

4.Automatic calibration occurs for which events? Select THREE.

A. whenever the device comes out of power save mode

B. when the printer is powered on after having been powered down for longer than 20 seconds

C. whenever a brand new print cartridge is installed in the printer

D. when 1,000 pages have printed since the last calibration

Answer: B,C,D

5.For what reason should you disassemble and then replace the paper feed assembly?

A. if repeated paper jams occur due to excessive paper skew

B. if replacing feed rollers and adjusting paper skew sensors do not solve repeated jam errors

C. if the mediasensor value no longer matches the value on the label located on the paper feed assembly

D. the paper feed assembly can be replaced as a full unit but should never be disassembled

Answer: D

    HP认证也是IT界认证考试中的一类非常重要的考试,如需下载更多的完整的题库,可登陆

 

阅读(308) | 评论(0) | 转发(0) |
给主人留下些什么吧!~~