分类： WINDOWS
2010-04-14 18:11:40
| Phoenix的BIOS版本内有一套完整的故障诊断机制。当系统存在硬件设置问题或故障时，除了通过响铃方式来说明故障现象外，还会出现相应的报错信息，可以根据响铃声音和报错代码表查询故障原因和解决方法。 |
自检响铃含义
| 自检响铃 | 自检响铃含义 |
| 1短 | 系统启动正常 |
| 1短1短2短 | 主板错误 |
| 1短1短4短 | ROM BIOS校验错误 |
| 1短2短2短 | DMA初始化失败 |
| 1短3短1短 | RAM刷新错误 |
| 1短3短3短 | 基本内存错误 |
| 1短4短2短 | 基本内存校验错误 |
| 1短4短4短 | EISA NMI口错误 |
| 3短1短1短 | 从DMA寄存器错误 |
| 3短1短3短 | 主中断处理寄存器错误 |
| 3短2短4短 | 键盘控制器错误 |
| 3短4短2短 | 显示错误 |
| 4短2短2短 | 关机错误 |
| 4短2短4短 | 保护模式中断错误 |
| 4短3短3短 | 时钟2错误 |
| 4短4短1短 | 串行口错误 |
| 4短4短3短 | 数字协处理器错误 |
| 1短1短1短 | 系统加电初始化失败 |
| 1短1短3短 | CMOS或电池失效 |
| 1短2短1短 | 系统时钟错误 |
| 1短2短3短 | DMA页寄存器错误 |
| 1短3短2短 | 基本内存错误 |
| 1短4短1短 | 基本内存地址线错误 |
| 1短4短3短 | EISA时序器错误 |
| 2短1短1短 | 前64K基本内存错误 |
| 3短1短2短 | 主DMA寄存器错误 |
| 3短1短4短 | 从中断处理寄存器错误 |
| 3短3短4短 | 屏幕存储器测试失败 |
| 3短4短3短 | 时钟错误 |
| 4短2短3短 | A20门错误 |
| 4短3短1短 | 内存错误 |
| 4短3短4短 | 时钟错误 |
| 4短4短2短 | 并行口错误 |
报错信息含义
|
报错代码 |
报错信息 |
诊断 |
处理方法 |
|
162
|
Configuration Error - Default configuration used |
CMOS has a bad checksum and/or CRC. |
Force user into Setup and reload default settings. |
|
164
|
Memory Size Error
|
System RAM size is less than expected. |
User corrects hardware problem or accepts new memory size in Setup. |
|
166 |
Boot Block Checksum Error |
The Boot Block Recovery segment of the Flash part has a bad checksum. |
Run Flash utility to update the Boot Block Recovery segment. |
|
167 |
No Processor BIOS update found. |
No microcode update image exists for the current CPU. |
User executes Flash update or Intel utility to install the proper level of CPU microcode. |
|
175 |
Primary Copy of Secure Data is Damaged |
First copy of security data has bad CRC. |
Report error and prompt for password. |
|
176 |
The System has been tampered with |
Cover tamper detected when a password is set, or SFC tamper detected. |
For cover tamper prompt for password, then clear after verification of password. For SFC tamper, refer to boot decision matrix. |
|
179 |
Boot Integrity Services Segment Error |
The BIS area checksum is invalid. |
Run Flash utility to update BIOS and checksum. |
|
184 |
Asset Control Antenna not Detected |
No antenna detected with AssetCare enabled. |
Auto-configure and request Administrator password (accept User password if no Administrator password set). |
|
186 |
Security Hardware Control Logic Error |
Could not read/write EEPROM or CRC is bad. |
Report security logic error. If Enhanced, report system locked and reboot message. If the error does not clear, a new planar is required. |
|
190 |
System security: Invalid Remote Change Requested |
Invalid remote configuration message. |
Clear the message, then prompt for password. |
|
191 |
System security: Lenovo Embedded Security Hardware Reset. |
|
|
|
192 |
System security: Lenovo Embedded Security hardware tamper detected. |
Security hardware |
|
|
193 |
System security: Lenovo Embedded Security Hardware Removed |
SFC missing. |
Refer to boot decision matrix. |
|
194 |
System security: Asset ID Antenna has been Removed |
AssetID antenna removed. |
Refer to AssetID antenna configuration matrix. |
|
195 |
System security: Asset ID Antenna has been Installed |
AssetID antenna added. |
Refer to AssetID antenna configuration matrix. |
|
196 |
System Tampered Cleared |
|
|
|
201 |
Memory Error |
Failure in Enhanced POST memory test, or the SPD indicates an installed DIMM/RIMM is not supported. |
Disable Enhanced POST, correct hardware problem, remove the DIMM/RIMM, or change the memory bus speed. |
|
210 |
Stuck Key |
Key stuck on keyboard. Only tested in Enhanced POST |
User corrects the stuck key or replace keyboard. |
|
211 |
Keyboard Error |
No keyboard has been detected. Do not display in Legacy Free mode or when Keyboardless Operation Mode is enabled. |
User installs a keyboard or corrects the stuck key. |
|
212 |
Keyboard Controller Failed |
|
