2012年(30)
分类: 系统运维
2012-02-25 09:46:58
1-NET UX1000-实战-配置
1. 实验目的
FXS Quick Start 1.1
Configuring a call for the UX1000 FXS
Use the following step to configure a UX 1000 FXS Port.
Lync 分机----呼叫---FXS分机
8288------6001
Verifying the UX Versions
Prerequisite! Check your software level.Verify that your UX1000 is loaded with firmware (boot partition) 2.1.6k and software image 2.0.0v108 or better. Older versions offirmware/software will cause the FXS card to not function.
To begin the configuration, verify your Boot and Application versions.
3.1. 选择-Settings
If the UX application image requires an upgrade, always upgrade the UX Communication Service software (UXSBA) before upgradingthe UX application software. The firmware (boot) image can be upgraded either before or after the UX application software.
Verify LicensingThe system must have the FXS and DSP licenses to make calls. Depending upon the types of calls, the Transcoding license may also be necessary.
Check to ensure that the FXS card and ports are functional by checking the System Tab | Overview Tab. The FXS Telco modules should show Activated, and the Service and Admin States should be UP.
Main Board:主板
FXS Not Activated and Up?Did you upgrade the firmware and software?
Make sure to set the Channel Hunting to Own Number, otherwise the first free channel will answer every call (regardless of any other configuration settings).
The FXS-attached phone should now have dial-tone.No dial-tone?
Are you certain your firmware and software are updated as noted at the beginning of these instructions?
SIP SG SIP信令组写入 SIP服务器FX0---也需要建信令组.需实战E1----也需要建信令组.需实战
11.4. Transformation
转换规则
11.5. Call Routing Table